Roof and Floor Electrode Cell Checklist
Product Support and Customer Service
For Further support visit our Contact Page
| ! | ? | X | Description | Comments, Exceptions, & Notes |
| Does Membrane Shell slope up at 1-2% so oxygen can leave the Cell? | ||||
| Is centerline of overflow nozzle 80 mm ( 3.2”) above the rim of the ED tank? or above the rim of the ED tank? | ||||
| Is compression washer flat? | ||||
| Is Electrode properly seated? | ||||
| Is cable lead connected to bus bar? | ||||
| Are the clamps over tightened? Are clamps square to strut channel? | ||||
| Is Cell Splash Guard or other drip shield installed properly? | ||||
| Is Cell electrolyte supply tubing trimmed & connected to supply manifold with a square cut end? –or-
Is Cell supply tubing connected to another Low Profile Cell and both ends are cut off square? |
||||
| Is Cell electrolyte return tubing cut square and pushed onto overflow nozzle? | ||||
| Is Cell electrolyte return tubing cut at 45 degree angle and stuck only 25 mm (~1”) into the opening Electrolyte Return Manifold? -or-
Is Cell return tubing cut off square and pushed onto a hose barb fitting, which is part of the Return Manifold? |
||||
| Are there any obstructions closer than 75 mm (~3”) to the Membrane Shell, below the liquid level? Or is Cell < 600 mm and within 100 mm of the centerline of eductor? | ||||
| Does any part of the Cell touch the wall or other structures? | ||||
| Is there a proper cable lead to each Cell? | ||||
| If multi-zone are diodes on lower voltage zone cells? | ||||
| Are Cells positioned per layout drawing? | ||||
| Are the strut supports joined properly? (Weld or Butt splices) | ||||
| Is the vertical supports plumb? Measure with bubble level every 5’ . | ||||
| Roof Cell Only: Is the minimum vertical height of the ED paint at least 30 mm above the Collar? | ||||
| Roof Cell Only: Is the minimum vertical height of the Collar at least 150 mm above the top most portion of the car body? | ||||
| Floor Cell Only: Is the minimum vertical height of the auto body/carrier at least 75 mm higher? |
Legend Description:
! - Needs Immediate attention ? - Some irregularity, probably ok X - Checked out fine